DeVilbiss DAPC Betreibershandbuch PDF herunterladen (Seite 11)

11 - Eng

D24156

CLEARING A JAM FROM THE TOOL

Disconnect tool from air supply before adjusting, clearing jams,

servicing, relocating or during non-operation. Failure to do so

could result in serious injury or property damage.

FASTENER JAM INSIDE MAGAZINE:

1. Disconnect tool from air hose.

2. Release the magazine latch to open the magazine.

3. Remove jammed fasteners.

4. Reload fasteners into magazine. Refer to Loading the Tool section in this

manual.

Stapler

Brad Nailer

Magazine Latch

FASTENER JAMMED IN FASTENER DISCHARGE AREA:

For Stapler

1. Disconnect tool from air hose.

2. Release the magazine latch to open

the magazine.

3. Remove fasteners from magazine.

4. Loosen the three screws on the driver

guide cover.

5. Remove the two screws holding the

driver guide cover to the gun body.

IMPORTANT: Before removing driver

guide cover note the orientation of all

parts.

6. Slide driver guide cover out until

jammed fastener is visible

7. Using pliers remove fasteners.

8. Slide drive guide cover into place and

line up holes in spring retainer and

bracket. Replace screws.

9. Tighten all screws securely.

10. Reload fasteners into magazine. Refer to Loading the Tool section in this

manual.

Remove

Magazine Latch

Loosen

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

DeVilbiss DAPC Betreibershandbuch Seite 11